If you check the box, then you also must enter a " Default Value" for it. The check box labeled " Is Required" is for when you want the Workshop to specifically use this parameter. Leaving it unchecked will cause the parameter not to show up in other dialog boxes. Make sure the " Use for Input" box is checked. You can also write a description of your parameter. Then, change its name, specify its " Data Type" (e.g. For each parameter, use the New Parameter button to initiate a new parameter. This is where you define the parameters of your device. Then, switch to the second tab of the dialog, "Parameters". You can also assign a category and write a description.ĭevice Manager's New Parameterized Subcircuit Model Dialog: General Tab. In this case, use the same name as your symbol, " MyBridge". In the first " General" tab, you enter a name for your parameterized subcircuit model definition, making sure that there are no spaces in the name. A dialog opens up with three tabs as shown below. Go to the Device Manager's File Menu and select New Parameterized Subcircuit Model Definition….
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |